13
INSTALLATION METHOD FOR THE WIRED
CONTROLLER (OPTIONAL)
1. Remove the top cover from the body of the Wi−Fi Translator by inserting a small
standard screw driver in the slit at the bottom of body and twisting.
2. Use the connective cable to connect the wire controller to CN3 of the Wi−Fi
translator PCB.
NOTE: Refer to the wired controller manual for details.
Fig. 25 - Connect the wired controller
smart port
C
N
3
4-core shielding wire
Extension cord
The connective wires group-2
wire controller
Fig. 26 - Connect the wired controller
To Next Page
Loading...
