Carrier Touch Pilot 33CNTPILOT - User Manual

This document is the property of Carrier Corporation and is delivered on the express condition that it is not to be disclosed,
reproduced in whole or in part, or used for manufacture by anyone other than Carrier Corporation without its written consent, and
that no right is granted to disclose or so use any information contained in said document.
Carrier reserves the right to change or modify the information or product described without prior notice and without incurring any
liability.
© 2006, Carrier Corporation 11-808-363-01 03/06
Touch Pilot
™
Installation and Operation Instructions
Part Number 33CNTPILOT
Introduction ................................................................. 1
About this Manual .................................................. 1
Safety Considerations .................................................. 1
General ......................................................................... 1
Installation ................................................................... 1
Location................................................................... 1
Power Transformer Wiring ...................................... 1
Carrier Network Communication Bus Wiring ........... 1
Communication Bus Wire Specifications ....... 1
Connection to the Communication Bus .......... 1
Mounting ................................................................ 2
Surface Mount................................................ 2
Decorative Bezel ............................................. 2
Chiller Display Mounting ............................... 2
Operation...................................................................... 4
Power-Up Display.................................................... 4
Default Device Designation............................ 4
Default Group Designation ............................. 4
Group Display Screen .............................................. 4
To Remove a Point from a Group Display....... 5
To Add a Point to a Group Display ................ 5
Navigation and Operation Pushbuttons.................. 5
BACK ............................................................. 5
HOME ............................................................. 5
MAIN MENU ................................................. 5
PREVIOUS ...................................................... 5
NEXT .............................................................. 5
OK .................................................................. 5
NO .................................................................. 5
CANCEL ......................................................... 5
CLEAR DATA ................................................ 5
RESET DATA................................................. 5
ADD ............................................................... 5
REMOVE ........................................................ 5
INC, DEC ........................................................ 5
SCROLL UP, DOWN ...................................... 5
PAGE UP, DOWN........................................... 5
FORCE ............................................................ 5
AUTO ............................................................. 5
MODIFY ......................................................... 5
ALARM INDICATOR LIGHT ........................ 5
START/STOP BUTTON ................................. 6
Main Menu.............................................................. 6
LOGIN ............................................................. 6
LOGOUT ......................................................... 6
SETUP ............................................................ 6
ATTACH ........................................................ 6
TIME .............................................................. 6
ALARMS ....................................................... 7
RESET ............................................................. 7
SCHED ............................................................ 7
STATUS, SETPNT, SERVICE, MAINT OR
CONFIG .......................................................... 7
Setup Menu Screen ................................................. 7
Configuration Tables ................................................... 8
User Configuration (USERCONF) Table.................. 8
BACKLIGHT ALWAYS ON? ......................... 8
FULL ACCESS PASSWORD .......................... 8
LIMITED ACCESS PASSWORD ................... 8
ACTIVE LANGUAGE PASSWORD ............... 8
ACTIVE LANGUAGE ..................................... 8
TIME FORMAT ............................................. 8
DATE FORMAT ............................................ 8
UNITS BASE .................................................. 8
CONTRAST CONTROL ................................. 9
NETWORK MODE ......................................... 9
ALARM ACKNOWLEDGER ......................... 9
BROADCAST ACKNOWLEDGER ................ 9
EQUIPMENT CCN ADDRESS .......................10
BUS NUMBER ...............................................10
ELEMENT NUMBER .....................................10
CONTROL VARIABLES ................................10
EQUIPMENT STATUS .................................10
EQUIPMENT START/STOP .........................10
ALARM STATUS .........................................10
ALARM RESET.............................................10

Summary

Introduction

About this Manual

Provides instructions for using the Touch Pilot as a Carrier communicating network user interface.

Safety Considerations

Installation

Location and Wiring Requirements

Details placement guidelines and electrical/communication wiring specifications for the Touch Pilot.

Mounting Procedures

Covers surface mounting, decorative bezel installation, and physical mounting steps for the unit.

Operation

Power-Up Display and Defaults

Explains the initial display sequence, default device, and group designations upon power-up.

Group Display Screen Functionality

Describes the layout, point buttons, and navigation within Group Display screens.

Point Management in Group Displays

Details how to add or remove points from group displays using the Point Data dialog box.

Navigation and Operation Controls

Lists and explains the function of various pushbuttons used for operating the display and navigating screens.

Main Menu Functions

Login, Logout, and Timeout

Covers user authentication, logout procedures, and the inactivity timeout feature.

Attach and Time Settings

Explains how to attach devices and adjust time/date settings.

System Alarms and Reset

Schedule and Status Functions

Setup Menu Screen

Display Setup Options

Configures regional, language, contrast, backlight, and touch screen calibration settings.

Passwords and CCN Settings

Configures system passwords and specifies display mode, CCN address, and network acknowledgers.

Configuration Tables

User Configuration Table

Details user-specific configurations like backlight, passwords, language, and formats.

Network Settings Configuration

Specifies settings for alarm and broadcast acknowledgers within the network.

Equipment Addressing

Specifies the CCN address (Bus Number and Element Number) for equipment in equipment mode.

Control Variables Configuration

Configures CCN variables for implementing Start/Stop Control and Alarm Indication functionality.

Carrier Touch Pilot 33CNTPILOT Specifications

General

Resolution	800 x 480 pixels
Power Supply	24 VAC ±15%, 50/60 Hz
Display Size	7 inches
Operating Temperature	32°F to 122°F (0°C to 50°C)
Screen Size	7 inches
Connectivity	Wired