Carrier WEATHERMAKER 39B - Page 11

Fig. 8 — Assembly of Accessory Face and Bypass Damper Section: Preheat Coil Section
and/or Spray Humidifier Section with and without Bypass — (Sizes 070-120)
3. Fasten flanges 2 thru 5 of preheat coil or spray
humidifier section without bypass to matching
flanges of cooling coil section with the following:
a. Fasten flanges 2 and 3 with three
3/8-16 x 3/4-in. hex head cap screws per
two flanges and matching flange weld nuts.
. Fasten flanges 4 and 5 with three 3/8-16 x
3/4-in. hex head cap screws and hex nuts per
two flanges.
4. Duct extension (for accessories with bypass) —
a. Preheat coil section only — Remove two
(size 070) or three (sizes 080 thru 120)
1/4-20 x l-in. hex head cap screws, plain
washers, and hex nuts from each flange 6
and 7. Save fasteners for following steps b
and c.
. Place endpiece having largest holes on side
C, on flange 6 of accessory. Face fiber glass
insulated side toward flange 7 of accessory.
Fasten surface A to flange6 of spray
humidifier section with one 1/4-20 x 1/2-in.
self-tapping screw and flange 6 engagement
hole. For preheat coil section, use two of
each type of fastener saved from preceding
step a.
. Place second endpiece on flange 7 of
accessory. Face fiber glass insulated side
toward fiber glass insulated side of first
endpiece. Fasten surface A to flange 7 per
preceding step b.
. Fasten one angle D to each side E of both
endpieces with two (size 070) or three
(sizes 080 thru 120) 1/4-20 x 1/2-in. self-
tapping screws per angle and side E engage-
ment holes.
. Fasten top panel to top of each endpiece
with one (spray humidifier section) or two
(preheat coil section) 1/4-20 x 1/2-in. self-
tapping screw(s) per end and engagement
hole(s) in top of each endpiece.