Carson X8N Chassis - Tools Needed for the Assembly; Your Radio System

CARSON X8N Chassis18
GB
Tools Needed for the Assembly
Scissors 300013305Needle nose pliers 300074034
Side cutter 300074035
Modelling knife 300074053
Hexagonal wrench 300013118Philips screwdriver (small and big)
and hex-wrench
1,5/ 2 / 2,5 mm 300074023
Instant adhesive 300053339
Tweezers 300074003
Please read the instructions provided with your radio system before
using it.
The servos must be set at the centre position before installation. To set
the servos at a neutral position, turn on the transmitter and receiver.
Set the trim levers in the centre position and turn off the receiver, and
then the transmitter. The servos will be in proper neutral position for
installation.
Receiver antenna
Receiverbattery
Engine throttle
servo
Steering servo
Switch
a. Your Radio System (only for RTR version)
o
n
)
Transmitter