Carver 3851CE - User Manual

CARVER
®
OPERATION, INSTALLATION AND MAINTENANCE MANUAL
TWO and FOUR POST MANUAL HYDRAULIC PRESSES
HEATED AND UNHEATED
IMPORTANT:
PLEASE READ CAREFULLY BEFORE INSTALLING OR OPERATING THIS EQUIPMENT
CARVER, INC.
1569 Morris Street, P.O. Box 544
Wabash, IN 46992-0544
PH: 260-563-7577 FAX: 260-563-7625

Summary

SECTION TWO: Safety Guidelines

2.1 Safety Considerations and Definitions

Explanation of safety terms (NOTICE, CAUTION, WARNING, DANGER) and general safety principles.

2.2 General Responsibility for Safety

Emphasizes safety as a vital aspect for all personnel involved with the press.

2.3 Operator Responsibility

Defines the operator's role in ensuring safe press operation and reporting hazards.

2.4 Mold Setter Responsibility

Highlights the mold setter's safety duties during mold installation and removal.

2.5 Maintenance Responsibility

Stresses safety as a priority for maintenance personnel during repair and upkeep.

SECTION THREE: Installation Procedures

Gauge and Ram Force Calculation

SECTION FOUR: Operation of Carver Presses

4.1 Operator Safety Guidelines

Essential safety practices for operators before, during, and after press operation.

4.2 Operating the Hydraulic Press

Step-by-step instructions for operating the press's hydraulic unit.

4.3 Daylight Adjustment Procedure

4.4 Heated Platens Operation

SECTION FIVE: Maintenance and Troubleshooting

5.1 Troubleshooting Common Issues

5.2 Hydraulic Unit Air Bleed Procedure

5.3 Electrical System Checks

Carver 3851CE Specifications

General

Model	3851CE
Type	Laboratory Press
Max Pressure	24 tons
Heating System	Electric
Cooling System	Water-cooled platens
Control System	Digital
Power Requirements	208/230V, 50/60 Hz, Single Phase