LHR Technologies, Inc. CarveWright™ System (Rev 1.39) 03/02/09 16
HARDWARE FEATURES (cont.)
FIGURE 13: CUTTING HEAD ASSEMBLY
F
IGURE 14: DIRECTIONAL CONVENTIONS
Y-Truck Guide Rails
Z-Truck Guide Rails
Vertical Moving Truc
(Z-Truck)
Horizontal Moving Truck
(Y-Truck)
Near
Far
X-Axis
Y-Axis
Right
Left
Z-Axis is up/down
Overhead View of Machine
(with workpiece)
Keypad
This corner (near left) of
the workpiece is the
coordinate origin for all
board measurements
Workpiece
Far-side
Also referred to as the
Front of the machine.
To Next Page