Casablanca Adapt Touch W-52

To Next Page

ADAPT•TOUCH™

Remote Fan & Light Control

Model W-52

Ratings: 120 VAC, 60 Hz, 1.0 Amp Fan

300 Watts incandescent light

Receiver Weight: 6 oz.

READ AND SAVE THESE INSTRUCTIONS

CAUTION: RISK OF ELECTRICAL SHOCK!

All wiring must be performed in accordance with national and local electrical codes. If you are unfamiliar with the

wiring codes, you should use a qualified electrician. To avoid overheating and possible damage to other equip-

ment, do not install control to a receptacle, fluorescent light fixture, motor operated appliance, or transformer-

supplied appliance. Use only to control one paddle-blade ceiling fan and attached incandescent light fixture.

NOTES:

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device must accept any interference received, including interfer-

ence that may cause undesired operation.

2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

3. For use only with Casablanca 3-Speed ceiling fans that use the Hang•Tru® canopy mounting system. Not for use with

other brands of ceiling fans.

4. Medium and Low fan speeds are determined by the Adapt•Touch™ control and thus may vary from the factory settings

due to normal motor variations.

BEFORE INSTALLING THE ADAPT•TOUCH™ CONTROL

Step 1. Use the pull-chain switch to set the fan speed to the

HIGH position before installation. Do not use the pull-chain

to change the fan speed after installation, as damage to your

ceiling fan or Adapt•Touch™ control may result. The speed

of the fan should only be changed by the Adapt•Touch™

control.

Step 2. Set the ceiling fan light kit to the ON position before

installation. The light level should only be changed by the

Adapt•Touch™ control.

P/N: 8943170 P/D: DEC99PDG

Need help?

Do you have a question about the Casablanca Adapt Touch W-52 and is the answer not in the manual?

Casablanca Adapt Touch W-52 Specifications

General

Brand	Casablanca
Model	Adapt Touch W-52
Category	Control Panel
Language	English

Casablanca Adapt Touch W-52 - User Manual

Summary

Safety and Compliance Information

Electrical Shock Hazard

FCC Compliance Statement

Installation Preparation and Wiring

Receiver Installation Preparation

Connecting Receiver to Wiring

Installing Receiver in Canopy

Connecting Fan Wiring and Transmitter Setup

Connecting Receiver and Fan Wires

Transmitter Preparation

Testing and Operation

Testing the Control System

Light Operation

Fan Operation

Manual Light Switch Operation

Troubleshooting and Warranty

Troubleshooting Common Issues

Limited Warranty Information