EasyManua.ls Logo

Casablanca Le Grande User Manual

Casablanca Le Grande
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
CIRCUIT BREAKER
(TRIP BREAKER FOR THE
CIRCUIT YOU WILL BE
WORKING ON)
FUSE BOX
(REMOVE FUSE FOR THE
CIRCUIT YOU WILL BE
WORKING ON)
The blades in each pack are matched for
equal weight to assure smooth fan operation.
If more than one fan is being installed, be
careful not to mix blades from different
cartons.
Inspect the contents of your carton for
possible shipping or handling damage and
report any such damage directly to your
authorized Casablanca dealer.
It is always a good idea to have an assistant
to help with the installation.
When cleaning, painting, or working near
your fan, be very careful of the fan and
blades. Always turn the power OFF to the
ceiling fan before servicing it, working on
it, or replacing light bulbs.
Never insert anything into the path of the
fan blades while the fan is in operation.
• Neverinstallafanoverapoolorspa.
Never operate a fan that has been damaged in
any way. Contact Casablanca Fan Company by
calling toll free 1-888-227-2178, or contact
your local authorized Casablanca dealer for
assistance in obtaining service.
CONTENTS
READ AND SAVE THESE INSTRUCTIONS
 All wiring must be in accordance with the National Electric Code ANSI/NFPA 70-1993 and the appropriate local electrical
codes. The National Electric Code requires proper grounding as a precaution against electrical shock. A qualified electri-
cian should be consulted if you are unsure.
• Thisfanisdesignedtobeinstalledonanexistingelectricaloutletbox.TheoutletboxmustbeULListedforceilingfan
installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling
installations.
 This ceiling fan requires a grounded electrical supply of 120 VAC, 60 Hz and a minimum 15 amp circuit. The maximum
current requirement for the fan with light fixture is 3.8 amps. The fan uses about 1 amp or 100 watts. Maximum light
current is 2.8 amps or 340 watts of lighting.
Where wire nuts are employed, be sure all bare wires are within the connectors. When installing the canopy hatch, make
sure all wires are within the canopy and that no wires are being pinched.
The fan must be supplied with 3 independent 120V AC supply wires to provide power for the fan, the light, and neutral.
For best performance and for your warranty to be valid,
use only genuine Casablanca blades, light fixtures, and accessories.
SAFE USE
Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the product
and proper installation; therefore, before attempting to install and operate your Casablanca fan, read this
owner’s manual completely and carefully. Retain this manual for future reference.
SAFETY FIRST
INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
MOUNTING RECOMMENDATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
PREPARATION INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
FAN INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
CONTROL FEATURES:
VERSA TOUCH2 OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
BEFORE YOU START
PN 8543010 AT0708
CAUTION: To avoid possible electrical shock, make certain that electricity is turned off at
the circuit breaker or fuse box before attempting any installation procedure.
18
84
Question and Answer IconNeed help?

Do you have a question about the Casablanca Le Grande and is the answer not in the manual?

Casablanca Le Grande Specifications

General IconGeneral
Blade MaterialWood
Number of Blades5
Remote ControlYes
Light Kit CompatibleYes
Mounting TypeDownrod
Light Kit IncludedNo

Summary

SAFETY FIRST

General Safety Precautions

Crucial safety information and warnings for safe fan installation and operation to prevent electrical shock.

BEFORE YOU START

Installation Requirements

Details electrical codes, outlet box specifications, and power supply requirements for fan installation.

MOUNTING RECOMMENDATIONS

Location Considerations

Guidance on selecting the optimal placement for the ceiling fan within a room for safety and performance.

SLOPED CEILING INSTALLATIONS

Extension Pole Usage

Explains when and how to use extension poles for high or sloped ceiling installations.

Sloped Ceiling Angle

Details how to determine if an adapter is needed for installation on sloped ceilings exceeding 32 degrees.

PREPARATION INSTRUCTIONS

Unpacking and Component Check

Guide to unpacking the fan, verifying carton contents, and checking hardware.

FAN ASSEMBLY AND MOUNTING PREP

Downrod and Ball Assembly

Detailed steps for installing the downrod into the motor coupling, ensuring secure attachment.

Outlet Box Requirements

Information on required ceiling outlet box specifications and installation checks for safety.

CROSSBAR MOUNTING BRACKET INSTALLATION

Bracket Installation Steps

Procedure for routing wires and attaching the crossbar mounting bracket to the ceiling outlet box.

CANOPY INSTALLATION

Attaching Canopy

Steps for attaching the canopy to the crossbar mounting bracket using screws and lock washers.

HANGING THE FAN

Securing Fan Body

Instructions on how to hang the fan body into the canopy, ensuring wires are not pinched.

CANOPY ELECTRICAL CONNECTIONS

Wiring the Fan

Detailed guide on connecting fan wires (ground, neutral, power) to the ceiling fixture outlet box wiring.

CANOPY HATCH INSTALLATION

Securing Canopy Hatch

Steps for tucking wires and installing the canopy hatch with the final canopy screw and lock washer.

ATTACH BLADE HOLDERS

Blade Holder Assembly

Instructions for attaching blade holders to the fan blades using screws and washers.

BLADE INSTALLATION

Attaching Blades to Motor

Procedure for attaching the assembled blades to the fan motor using the provided screws.

VERSA TOUCH 2 INSTALLATION

Control Bracket Installation

Guidance on installing the Versa Touch 2 control bracket onto standard or rocker light switches.

Wall Installation

Instructions for mounting the Versa Touch 2 control bracket directly to a wall stud.

VERSA TOUCH 2 OPERATION

Fan Control Functions

Explanation of how to operate the fan speed, airflow direction, and light settings.

Changing Frequency Setting

Procedure to change the dip switch settings for controlling multiple fans independently.

Troubleshooting Fan Operation

Steps to resolve common issues if the fan is not functioning correctly after installation.

TROUBLESHOOTING TIPS

Common Fan Problems and Solutions

A guide to diagnosing and resolving issues such as fan not starting, wobbling, or noise.

CARE RECOMMENDATIONS

Cleaning and Maintenance

Instructions for cleaning fan finishes and blades to maintain their appearance and longevity.

Lubrication Information

Important note stating that the fan motor does not require lubrication.

PRODUCT SPECIFICATIONS

Fan Model and Dimensions

Details on the fan's model number, physical dimensions, and weight.

Performance Data

Information on motor type, blade span, pitch, airflow, and electricity usage.

Related product manuals