To Next PageTo Next Page
Need help?Do you have a question about the Case IH FARMALL 30A and is the answer not in the manual?
General| Engine Power | 30 HP |
|---|---|
| Engine Type | 3-cylinder diesel |
| Transmission | 8x8 Synchro Shuttle |
| Weight | 2, 425 lbs |
| Drive | 4WD |
| PTO Speed | 540 RPM |
| Hydraulic Flow | 6.6 gpm |
Provides guidance on safe handling and disposal of fluids and materials.
Information on the proper environmental disposal and return of used batteries.
Warning regarding potential health risks associated with diesel exhaust and battery components.
Explanation of safety alert symbols (Danger, Warning, Caution) and their meanings.
Guidelines for preventing machine damage and avoiding workshop accidents.
Guidance on shimming, seal installation, sealing compounds, and spare parts.
Precautions for protecting electrical systems during charging or welding.
Instructions for using metric hardware, plating, locknuts, and thread lubrication.
Minimum tightening torques for inch-sized non-flanged hardware and locknuts.
Minimum tightening torques for metric non-flanged hardware and locknuts.
Torque specifications for National Pipe Thread (NPT) fittings.
Procedure for installing and torquing 37-degree flared fittings.
Engine type, displacement, fuel requirements, and emission standards.
Fluid capacities for various tractor systems and cooling system details.
Details on transmissions, PTO systems, and service brakes.
Details on electrical components, steering, and hydraulic lift systems.
Information on tire sizes, wheel torques, and ROPS attachment specifications.
Guidelines and conditions for using biodiesel fuel blends in the tractor.
Specifies the minimum clearance under the tractor drawbar for different tire types.
Key wheelbase and overall length measurements for the tractor.
Details on tractor weight with ROPS and without tires.
Specific CASE IH AKCELA engine oils, part numbers, and container sizes.
Recommended fluids for transmission, hydraulic systems, and front axle.
Location of the engine identification plate on the engine block.
Illustrations defining left-hand, right-hand, front, and rear perspectives of the tractor.
Detailed service information for the engine and crankcase assembly.
Procedure for disconnecting the tractor from the engine at the clutch housing.
Procedure for disconnecting the tractor from the center case and rear axle.
