Case IH Magnum 180 User Manual

PrintedinU.S.A.
Copyright © 2014 CNHIndustrial America LLC. All Rights Reserved.
Case IHisaregisteredtrademarkofCNH Industrial America LLC.
Racine Wisconsin 53404 U.S.A.
Magnum
™
180
Magnum
™
200
Magnum
™
220
Magnum
™
240
Continuously Variable Transmission (CVT)
Tractor
PIN ZERH08100 and above
Part number 47748092
1
st
edition English
September 2014
SERVICE MANUAL

Case IH Magnum 180 Specifications

General

Engine Power	180 hp
Cylinders	6
Displacement	6.7L
Transmission	Full Powershift
3-Point Hitch	Category III
PTO Speed	1000 rpm

Summary

INTRODUCTION

Foreword - Important notice regarding equipment servicing

General disclaimer and important notices for equipment servicing and repair.

Safety rules

Guidelines and warnings to prevent personal injury and property damage.

Torque - Minimum tightening torques for normal assembly

Specifications for tightening torques for various hardware sizes and classes.

Capacities

Lists fluid capacities for engine oil, cooling, transmission, and fuel tank.

Product identification

Information on identifying the tractor's model, PIN, and serial numbers.

Engine - 10

Engine and crankcase

Procedures for removing and installing the engine and crankcase assembly.

Fuel tanks

Procedures for removing and installing the tractor's fuel tanks.

Fuel injection system

Information on the tractor's fuel injection system components and settings.

Air cleaners and lines

Maintenance and service procedures for the air intake system.

Selective Catalytic Reduction (SCR) exhaust treatment

Information regarding the SCR system for emissions control.