INTRODUCTION, SAFETY, PLATES AND DECALS
1-15
Place some wedges under the wheels so as to pre-
vent the machine from moving.
Unauthorized modifications of the machine can
cause serious injuries. Do not carry out any modifi-
cation on this machine without obtaining prior
authorization from your Dealer. Any modification
carried out must be in conformity with the machine’s
technical specifications and must conform to current
safety regulations.
Do not carry out any welding operation on the
machine without prior authorization from your
Dealer.
Some of the machine’s components are subject to
type approvals. It is mandatory when replacing
those components to ensure that they are in con-
formity with regulations.
Hydraulic fluid or grease under pressure which pen-
etrates the skin can cause serious injury. Take the
necessary safety precautions (protective clothing
and face and hand protection) to prevent all such
risks. In addition, before handling these products,
read the manufacturer’s specific instructions for
their use. If hydraulic fluid penetrates the skin a doc-
tor must be called immediately.
When carrying out a welding operation on the
machine, as authorized by the manufacturer and in
accordance with his specifications, disconnect the
alternator plug and connect the welding set ground
lead to the component on which the welding is to be
carried out. Never connect the ground lead to a
hydraulic system component.
A burst tyre can cause serious injury. Regularly
check the condition of tyres and always observe the
inflation pressures defined in accordance with the
type of tyre and ground conditions.
When checking tyre pressures or during an inflation
operation, never stay facing the tyre but always fac-
ing the tread surface. Always use an inflation cage
when the wheel is removed from the machine. Keep
all other persons away from the area.
Never weld near a tyre. It is essential to remove the
tyre before any welding operation.
Take the necessary safety measures to protect your
face when using compressed air.
The machine’s structure is in conformity with the
FOPS and ROPS protection standards. Any modifi-
cation (drilling, welding, etc.) may cause that con-
formity to be invalidated.
14
15
To Next Page
Loading...
