SECTION 00 - INTRODUCTION 9
2.7 FLAMMABLE LIQUIDS
When handling flammable liquids:
do not smoke;
keep away from unshielded light sources and na-
ked flames.
Fuels often have a low flash point and are readily ig-
nited.
Never attempt to extinguish burning liquids with wa-
ter. Use:
dry powder;
with carbon dioxide;
with foam.
Water used for extinguishing purposes would vapor-
ize instantaneously on contact with burning sub-
stances and spread burning oil, for example, over a
wide area. Water generates short circuits in the elec-
trical system, possibly producing new hazards.
Stay away from open flames during refilling of hy-
draulic oil or fuel.
Fuel or oil splashes can cause slipping and therefore
accidents; clean immediately and accurately the ar-
eas eventually smeared.
Always tighten the safety plugs of fuel tank and hy-
draulic oil tank firmly.
Never use fuel to clean the machine parts eventually
smeared with oil or dust.
Use a non-inflammable product for cleaning parts.
Always perform fuel or oil refilling in well aired and
ventilated areas.
During refuelling hold the pistol firmly and keep it al-
ways in contact with the filler neck until the end of the
refuelling, to avoid sparkles due to static electricity.
Do not overfill the tank but leave a space for fuel ex-
pansion.
Never refuel when the engine is running.
Take all the necessary safety measures when weld-
ing, grinding or when working near a naked flame.
To Next Page
Loading...
