Case H80 - Page 9

CHUTE AND
-DEFLEcToR
HEX HEAD
CRANK
SPIROL
8.
5.
9.
6.
10.
Figure
12.
Remove
the safety
pins
fromtheliftarm.
With
the
plain
washer located
next to
the cotter
pin
as shown in
Figure
13,
place
the
lift
arm through
the
auger
lift
brackets.
Iower
the
lift lever
to
align the lift
arm. Connect the lift
arm
to the lift
lever
pin
with
the
plain
washer
and
safety
pin.
i::stall the other safety
pin
through the
lift arm
at
the
inside
of
the
right lift
bracket.
?.
Apply
a
coat of
grease
around
the out-
side
of the discharge
spout
as shown
in Figure
13.
LIFT
ARM
5AF ETY
PIN
LIFT
PLAIN
WASHER
PLAIN
WASHER
GREASE
DISCHARGE SPOUT
Figure
13.
Figure
14.
Apply
a
coat
of
grease
to
both
sides of
the notched
chute base ring. Place
the
chute
over discharge
spout and engage
the
base
ring notches
with the crank
spirol.
See
Figure
14.
Individualiy
align thetwo
side
chute
guides
with
the
square
holes
in the
discharge
spout and secure
with
round
head
bolts. Install
the
bolts with
the round
head at
the
inside
of the dis-
charge spout.
Install
the front
chute
guide
using
the
hex
head
bolt. This
bolt should
be in-
stalled
from the outside
with
the nut and
lockwasher
to
the inside.
lQfE
Check
to
make
certain
the three
guides
are square with
the
chute
base ring
to
prevent
the
chute from
binding
when turning
the
crank.
BLOCK
JOINT
--'#
RANK
:&
\1
SUPPORT
SPIROL
ADJUSTING
BRACKET
qd:;i$,,,,,,.
SAF
PIN
ATTACHMENT
DRIVE CLUTCH
L
EVER
Figure
15.