r
10.
Check to make sure the belt is properly located in each
pulley. Turn the adjusting crank counterclockwise to
tension the belt until the idler spring coils open 1/8
inch (approximately the thickness of two nickels. See
Figure 5 and 14.) Disengage the attachment drive lever
and reconnect the spark plug wire(s).
IMPORTANT Before operating the mower, review and
follow the recommendations outlined
in the adjustments and Maintenance-
section of this manual.
The J I Case Company reserves the
right to make improvements in
design changes in specifications at
any time without incurring any
obligations to install them on units
previously
sold.
Printed
in U. S. A.
40 i
CMTHO
15
casecoltingersoll.com
To Next Page
Loading...
