1002 - 4
SPX 4260 Troubleshooting Manual
Issued 2-03 Printed in U.S.A. General Information And Specifications
GENERAL INFORMATION
Cleaning
Clean all metal parts except bearings, in mineral spirits or by steam cleaning. Do not use caustic soda for
steam cleaning. After cleaning, dry and put oil on all parts. Clean oil passages with compressed air.
Inspection
Check all parts when the parts are disassembled. Replace all parts that have excessive wear or are damaged.
Small scoring or groves can be removed with a hone or crocus cloth. Complete visual inspections for
indications of wear, pitting and the replacement of parts necessary will prevent early failures.
Bearings
Clean bearings with a good clean solvent and permit to air dry. DO NOT DRY BEARINGS WITH
COMPRESSED AIR. Check bearings for smooth easy action. If the bearing has a loose fit or rough action, the
bearing must be replaced.
Needle Bearings
Before you press needle bearings into a bore, always remove any metal protrusions in the bore or the edge of
the bore. Before you press bearings into position, put petroleum jelly on the inside and outside diameter of the
bearing.
Gears
Check all gears for excessive wear or damage. Replace gears as necessary.
Oil Seals, O-rings and Gaskets
Always install new oil seals, O-rings and gaskets. Put petroleum jelly on seals and O-rings.
Shafts
Check all shafts for excessive wear or damage. Check the bearing and oil seal surfaces on the shafts for
excessive wear or damage. Replace shafts as necessary.
Service Parts
Always install genuine Case service parts. When ordering refer to the Parts Catalog for the correct part number
of genuine Case replacement items. Failures due to the use of other than genuine Case replacement parts are
not covered by warranty.
Lubrication
Use only the oils and lubrication specified in the Operators Manual. Failures due to the use of non specified oils
and lubricants are not covered by warranty.
To Next Page
Loading...
