2-12
S
SAFETY PRECAUTIONS
F24052
F1442
F1443
USE HANDHOLDS AND STEPS
Falling is one of the major causes of personal injury.
When you get on and off the machine, always maintain
a three-point contact with the steps and handrails and
face the machine.
Do not use any controls as hand-holds.
Never jump on or off the machine.
Never mount or dismount a moving machine.
Be careful of slippery conditions on platforms, steps,
and handrails when leaving the machine.
ADJUST THE SEAT
A seat poorly adjusted for operator or work require-
ments may quickly fatigue the operator leading to
improper operations.
• The seat should be adjusted whenever machine
operator changes.
• The operator should be able to fully press the pedals
and correctly move the control levers with his back
resting against the seat back.
• If not, move the seat fore and aft, and check again.
OPERATE ONLY FROM THE DRIVER’S
SEAT
To start the motor with an unsuitable procedure may
cause sudden movement of the machine with possibility
to cause serious injuries or mortal incidents.
• Start the engine only from the driver’s seat.
• Do not start the engine by shorting across starter
motor terminals.
• Before starting the engine, ensure that all control
levers are in the neutral position.
To Next Page
Loading...
