2-16
S
SAFETY PRECAUTIONS
F24672
F23960
RULES FOR ROAD TRANSFER
The machine is equipped with safety locks to be used
for road transfer.
When transfer is necessary:
• Position the upper structure toward the front swinging
axle and insert the anti-rotation lock.
• Locate cylinders as shown in homologation configu-
ration.
• Lock cylinders (cocks, reference marks).
• Lift stabilizers and blade (if equipped).
• Disengage control levers for attachments by shifting
lever of safety equipment in lock position.
On the road follow the rules regulating traffic.
During road transfers always disconnect front axle
lock.
INVESTIGATE JOB SITE BEFORE HAND
Clear all persons from area of operation and machine
movement.
Make sure worksite footing has sufficient strength to
firmly support the machine.
When working close to an excavation, operate the
machine with che chassis frame positioned perpen-
dicular to the cliff face, so that the machine can more
easily evacuate if the cliff face collapses. Confirm that
your machine is equipped with a F.O.P.S. (Falling
Object Protective Structure) cab before working in
areas where there is the possibility of falling stones or
landslides.
When digging deeply, avoid hitting bottom of boom or
bucket cylinder hoses against the ground.
Use the bucket only for digging.
To avoid accidents, do not use it as a jack hammer or
wrecking ball.
To Next Page
Loading...
