Casio DT-930 Series - Checking Application Program Size

15
2.8 Checking Application Program Size
The application program size on the terminal is not the same as the size of download files, *.MOT
or *.LOD file explained in Chapter 2.7. To know the correct size of your application program, see
MAP file generated by linker. The distance from the start address in it to the end address is exactly
the size of your application program. If you require to know only whether your application program
can be put in the application area of the terminal, check the end address from MAP file. However,
when the size of application program area of the terminal is changed, the end address of this area is
also changed. The default size of application program area and the address map of the terminal are
as follows.
Table 2.2 Default size of the application program area
Size of the area Address map
DT-930 series Approx. 336 Kbytes 09048030h to 0909C000h
In order to get the start address and the end address of the application program from the MAP file,
refer to “SECTION NAME*” and “*TOTAL ADDRESS*”
ATTRIBUTE : CODE NOSHR START END LENGTH UNIT NAME
P H'???????? - H'???????? H'????????
AP
_
Start AP
_
Start
H'???????? - H'???????? H'????????
apsmp apsmp
H'???????? - H'???????? H'????????
__slow_mvn
__
slow
_
mvn
* TOTAL ADDRESS * H'09048030 - H'???????? H'????????
ATTRIBUTE : DATA NOSHR
C H'???????? - H'???????? H'????????
AP
_
Start AP
_
Start
H'???????? - H'???????? H'????????
ap_init ap
_
init
H'???????? - H'???????? H'????????
apsmp apsmp
* TOTAL ADDRESS * H'???????? - H'???????? H'????????
ATTRIBUTE : DATA NOSHR RAM
R H'???????? - H'???????? H'????????
AP_Start AP_Start
H'???????? - H'???????? H'????????
ap
_
init ap
_
init
H'???????? - H'???????? H'????????
apsmp apsmp
* TOTAL ADDRESS * H'???????? - H'???????? H'????????
The start address of the application program is the address at START in TOTAL ADDRESS line
of ATTRIBUTE “P”. The address here must be 09048030. The end address of the application
program is the address at END in TOTAL ADDRESS line of ATTRIBUTE “R”. The size of the
application program is the difference between these two addresses.