E-45
You can use the FREQ column to specify the frequency (the number
of times the same sample appears in the group of data) of each
sample value.
Rules for Inputting Sample Data on the STAT Editor
Screen
•Data you input is inserted into the cell where the cursor is located.
Use the cursor keys to move the cursor between cells.
• The values and expressions you can input on the STAT editor
screen are the same as those you can input in the COMP Mode
with Linear format.
•Pressing A while inputting data clears your current input.
•After inputting a value, press =. This registers the value and
displays up to six of its digits in the currently selected cell.
Example: To input the value 123.45 in cell X1
(Move the cursor to cell X1.)
123.45
=
Registering a value causes the cursor to move down one cell.
STAT Editor Screen Input Precautions
• The number of lines in STAT editor screen (the number of sample
data values you can input) depends on the type of statistical data
you selected, and on the Statistical Display setting of the calculator’s
setup screen.
STAT
Cursor
The value you input appears
in the formula area.
ON
(FREQ column)
Statistical
Display
Statistic Type
OFF
(No FREQ column)
Single-variable
Paired-variable
80 lines
40 lines
40 lines
26 lines
• The following types of input are not allowed on the STAT editor
screen.
• m, 1m(M–) operations
•Assignment to variables (STO)
STAT
STAT
To Next Page
Loading...
