Casio fx-9860G AU PLUS Hardware User's Guide

E-11
Turning off the calculator while editing an eActivity and then changing batteries can cause
the data you are editing to be deleted. Be sure to save the eActivity data before turning off
the calculator and changing batteries.
1. Press !o(OFF) to turn off the calculator.
Warning!
• Be sure to turn the calculator off before replacing batteries. Replacing batteries with power
on will cause data in memory to be deleted.
2. Making sure that you do not accidently press the o key, slide the case onto the calculator
and then turn it over.
3. Remove the battery cover from the calculator by
pulling with your finger at the point marked 1.
4. Remove the four old batteries.
5. Load a new set of four batteries, making sure that
their positive (+) and negative (–) ends are facing in
the proper directions.
6. Replace the battery cover.
7. Turn the calculator front side up and slide off its
case. Next, press o to turn on power.
• If the figures on the display appear too light and hard to see after you turn on power, adjust
the contrast.
k About the Auto Power Off Function
Calculator power turns off automatically if you do not perform any operation within the Auto
Power Off trigger time you specify. You can specify either approximately 10 minutes or
approximately 60 minutes as the trigger time (see “Power Properties Settings” on page 12-1).
To restore power, press o.
11
1
1
fx-9750GII
fx-7400GII
fx-9860GII SD
fx-9860GII
fx-9860GII s
fx-9860G AU PLUS
1
1
fx-9750GII
fx-7400GII
fx-9860GII SD
fx-9860GII
fx-9860GII s
fx-9860G AU PLUS

Casio fx-9860G AU PLUS Specifications

General

Model	fx-9860G AU PLUS
Category	Graphing Calculator
Power Supply	4 AAA batteries
Memory	1.5 MB (user-accessible)
Connectivity	USB
Functions	Graphing, equation solving, statistical calculations
Programming	CASIO BASIC
Display	64 x 128 pixel LCD