Casio FX6300G - Page 63

9
Binary, Octal, Decimal, Hexadecimal
Calculations
•Binary, octal, decimal and hexadecimal calculations, conversions and logical oper
ations are performed in the BASE-N mode (press S B ) -
•The number system (2, 8, 10, 16) is set by respectively pressing S , (oct), [dec) 0r
(hex) followed by («£). A corresponding symbol — “ b” , “ o” , “d” or “ H” appears
on the display.
•Number systems are specified for specific values by pressing S , then the number
system designator (b, o, d, or h), immediately followed by the value.
•General function calculations cannot be performed in the BASE-N mode.
•Only integers can be handled in the BASE-N mode. If a calculation produces
a result that includes a decimal value, the decimal portion is cut off.
•Octal, decimal and hexadecimal calculations can be handled up to 32 bits, while
binary can be handled up to 12 bits.
Number system Number of digits displayed
Binary Up to 12 digits
Octal Up to 11 digits
Decimal
Up to 10 digits
Hexadecimal Up to 8 digits
•The total range of numbers handled in this mode is 0, 1, 2, 3, 4, 5, 6, 7, 8, 9,
A, B, C, D, E, F. If values not valid for the particular number system are used,
attach the corresponding designator (b, o, d or h), or an error message will appear.
Number system
Valid values
Binary
0, 1
Octal
0, 1, 2, 3, 4, 5, 6, 7
Decimal
0, 1, 2, 3, 4, 5, 6, 7, 8, 9
Hexadecimal
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, A, B, C, D, E, F
- 6 2 -