3. Use (D) to display the setting you want to
change.
●
Each press of (D) cycles through
settings in the sequence shown below.
Summer time
Home City
Minutes
Hours
Seconds
Day
Month
Ye a r
12/24-hour timekeeping
Changing Units
Illumination duration
Operation tone enable/disable
Power Saving
4. Configure the date and time settings.
●
While the seconds are flashing,
pressing (A) will reset them to 00. 1 is
added to the minutes when the current
seconds count is between 30 and 59
seconds.
●
For all the other settings, use (A) and (C)
to change the flashing setting.
Holding down (A) or (C) scrolls through
settings at high speed.
5. Repeat steps 3 and 4 to select time and
date settings.
6. Press (E) twice to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
Switching between 12-hour and 24-
hour Timekeeping
You can specify either 12-hour format or 24-
hour format for the time display.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (E) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3. Press (D) twice.
This causes [12H] or [24H] to flash on the
display.
4. Press (A) to select [12H] (12-hour
timekeeping) or [24H] (24-hour
timekeeping).
Each press of (A) toggles between 12-
hour and 24-hour timekeeping.
●
[P] is displayed during p.m. times while
12-hour timekeeping is being used.
24-hour timekeeping12-hour timekeeping
5. Press (E) twice to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 3553
14
To Next Page
Loading...
