Casio SF-4300B - Page 40

yin.
PART 6 Data Communications
To send all data items
1.
APoONM
76
While an initial screen in displayed, press FUNC twice to display the second
function menu.
Youcan perform the above operation while the intial screen of the Telephone
Directory, Memo Mode, Schedule Keeper, Calendar, Reminder is displayed.
Note that this operation sends all open memory area data or all secret
memory area data. Make sure you are in the memory area you want (open
or secret) before proceeding.
Press 4 to select DATA COMM.
Press 1 to select SEND.
Press 3 to select ALL DATA.
Press SET to start the send operation or ESC to abort the operation without
sending anything.
Ceay SEND ING
DATA +
O STOP
mee PRESSTESC?
Data is sent in the sequence: Telephone Directory, Memo Mode, Reminder
Mode, Schedule Keeper, Calendar.
To abort the send operation at any time, press ESC.
If an error occurs during the send operation, the message “TRANSMIT
ERROR!" appears on the display. Press ESC to clear the error message.
Some SF Units do not have modes that are included with this unit. For
example, some units do not have a Reminder Mode. Data from a mode
cannat be received by an SF Unit unless that SF Unit also has the same
mode. When sending data to a personal computer, certain mode data may
be disregarded, depending upon the version of software you are using for
SF data handling on the personal computer.
After the send operation is complete, the display returns to the initial screen
of the mode you were in when you started this procedure.
foe
ATA
Sending Data
To send one Telephone Directory, Memo Mode, or
Reminder Mode item
in the Telephone Directory, Memo Mode, or Reminder Mode, press FUN2
twice to display the second function menu.
You can perform the following operation white in the open memory area or the
secret memory area.
Press 4 to select DATA COMM.
Press 1 to select SEND.
Press 1 to select ONE ITEM.
Press A or V to show an index display of items stored in memory.
Pressing V starts the index display from the top of the data items, while
pressing A starts from the bottom.
You could aiso use initial character search or mode search to locate the data
you want tosend.
Use A and V to scroll through the index display until the item you want to
send is located in the top line.
Press DISP CHNG to switch to the data display of the selected item.
Press SET to start the send operation or ESC to abort the operation without
sending anything.
Copou SENDING
DATA
TO _ STOP
i> PRESSCESCD
GES B
To abort the send operation at any time, press ESC.
If an error occurs during the send operation, the message “TRANSMIT
ERROR!” appears on the display. Press ESC to clear the error message.
Note that you cannot send Reminder Mode data from the SF Unit to an S=
Unit that does not have a Reminder Mode, or to a personal computer.
To interrupt a data transfer operation, press ESC.
MY ~s
head