What to do if my CASO DESIGN VC 10 isn't creating a complete vacuum?
If your CASO DESIGN Food Saver isn't creating a complete vacuum, it might be due to several reasons. Make sure the open end of the bag is completely inside the vacuum chamber. Also, the bag itself could be defective, so try using another bag. Finally, check for any dirt on the welding and normal seals; if there is dirt, clean the seals and retry once they are dry.
Why doesn't my CASO DESIGN Food Saver bag hold vacuum after welding?
If your CASO DESIGN Food Saver bag doesn't hold the vacuum after being welded shut, consider these possibilities. The bag could be defective, so try using another one and wrap paper towel or napkin around any sharp edges on the content. Alternatively, there may be leaks along the welding seam due to creases, crumbs, grease, or liquids. In that case, open the bag, clean the upper internal part, and remove any foreign matter from the welding bar before welding it shut again.
Why is my CASO DESIGN Food Saver vacuum unit not working?
Your CASO DESIGN Food Saver vacuum unit might not be functioning due to a few reasons. First, ensure the power plug is properly plugged into the electrical socket. If it is, check if the power cable or plug is defective, and if so, contact Customer Service. Finally, the electrical socket itself could be defective, so try using another socket.
How to fix the first weld on the cut off piece of the roll if it is not being carried out by my CASO DESIGN VC 10?
The roll might not be positioned correctly. Follow the steps in the chapter “making a bag using the bag roll”.
Essential safety instructions for operating the vacuum sealer system.
Details on manual content, warning notices, and liability limitations.
Defines the device's intended purpose and provides general safety practices.
Highlights potential hazards such as burns, fire, and electrical dangers.
Provides specific procedures for vacuum sealing to ensure food quality and safety.
Covers safety regarding packaging materials and inspecting the delivery.
Details the device's functions and the process for unpacking.
Guidance on the environmentally responsible disposal of packaging.
Specifies the necessary conditions for the device's placement.
Instructions for safely connecting the device to a power source.
Identifies and describes all parts of the vacuum sealing system.
Explains the control panel functions and the information on the rating plate.
Step-by-step guide for using the vacuum sealer correctly.
Information on recommended bags and rolls for vacuum sealing.
Instructions for creating custom bags and performing vacuum sealing.
Detailed usage of the pulse vacuum feature for delicate foods.
Guide for vacuum sealing items using canisters.
Helpful advice for optimal vacuum sealing of various food types.
Instructions on how to properly open a vacuum-sealed bag.
Recommendations for storing the device when not in use.
Crucial safety notices to follow before cleaning the device.
Step-by-step guide for cleaning the inside and outside of the unit.
Safety precautions related to device repair and troubleshooting.
Lists common errors, their possible causes, and recommended solutions.
Instructions for the proper and environmentally friendly disposal of old units.
Information regarding the 12 months limited warranty for the product.
General| Sealing Bar Length | 30 cm |
|---|---|
| Voltage | 220-240 V |
| Functions | Sealing |
| Material | Stainless steel / Plastic |
| Color | Silver |
To Next Page
