Commissioning
caso Eierkocher 35
13.3 Setup location requirements:
In order to ensure the safe and trouble-free operation of the
device, the setup location must fulfil the following prerequisites:
The device must be set up on a firm, flat, horizontal and water-
resistant surface with sufficient load-bearing capacity for the air
humidifier and content.
Choose the setup location in such a way that children cannot
reach the device.
The device is not intended to be installed in a wall or a built-in
cupboard.
Do not set up the device in a hot, wet or extremely damp
environment or near flammable material.
Do not cover up any openings on the device and do not block
these off.
The electrical socket must be easily accessible so that the
power lead can be disconnected easily, in the case of an
emergency.
The installation and assembly of this device in non-stationary
setup locations (e.g. on ships) must be carried out by specialist
companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
To Next Page
Loading...
