then set desired temperature. The two control panels are working independently
from each other.
The temperature in the device depends on the room temperature, the quantity of
bottles/ amount of food and the chosen temperature. Please note that your device is
intended to cool food and beverages. The maximum temperature that can be
reached inside the device cannot be significantly ABOVE the ambient temperature at
the setup location.
When you open the drawer the actual temperature is displayed.
Please note
► The device beeps when the drawers is opened too long and the display shows DR
to remind you to close the drawer.
► Let the device work for 2 hours before placing food/beverages into the device.
► If not further operation is performed within 2 seconds, then the displayed
temperature is confirmed and stops flashing.
Eco Mode
Press button for 3 seconds until ECO is displayed. The temperature for
both drawers is set to 5 °C automatically.
5.3 Charging via USB
As soon as the device is switched on, you can charge via the two USB ports.
5.4 Instruction for storage of food / beverages in the device:
• It is important to store food / beverages properly.
• Do not store food in the device which is easliyl addled at low temperatures, such
as bananas, tropical frutis. They may discolor and the vitamin content may be
reduced.
• Do not place hot food / beverages into the device. Let them cool down before
placing into the device. The adding of hot food / beverages would affect the
temperature of the device and affect the freshness of other food / beverages.
• Do not open the device too frequently as this will allow warm air to enter the
device and the inside temperature will rise.
• Store food in containers and bags so that the smelle and taste of the food will not
be influenced.
• Food such as fruit and vegetables shall be cleaned before storage. This is also
recommened for the packaging of food. So other food will not be affected.
To Next Page
Loading...
Need help?
General