[Type here] [Type here] [Type here]
For repetitive cuts on multiple pieces, Castle offers an optional work stop assembly
which can be adjusted to position pockets where desired and allow the operator to
simply place the stock against the stops on either side for accurate and repeatable
positioning. This accessory is especially useful for production of multiple parts where
speed and repeatability are important. See section 10 in the manual.
7 Vacuum Port
When possible, Castle recommends using a dust extraction vacuum to keep the tool
free of chips and dust. The Castle 110 includes a vacuum port that is sized to fit
most modern shop vacs and universal shop vacuum hose adapters. Select the dust
extraction hose adapter that will work with your system. When operating your Castle
110 without dust extraction connected, we recommend removing any dust
accumulation inside the housing after several cuts. Excessive dust accumulation
restricts air flow and can damage to the motor. Additionally, inspect the router motor
to ensure excessive chips and dust are not obstructing the air intake vents of the
motor.
Vacuum Port
To Next Page
Loading...