Need help?Do you have a question about the Castwin DME-9724HM and is the answer not in the manual?
General| Model | DME-9724HM |
|---|---|
| Category | Media Converter |
| Ports | 1 x RJ45, 1 x SFP |
| Data Rate | 10/100/1000Mbps |
| Interface | RJ45, SFP |
| Fiber Type | Single-mode or Multi-mode |
| Wavelength | 850nm/1310nm/1550nm (depending on SFP module) |
| Transmission Distance | 2km(Multi-mode), 20-120km(Single-mode) (depending on SFP module) |
| Power Supply | 5V DC, 1A |
| Operating Temperature | 0°C ~ 50°C |
| Humidity | 5% ~ 90% non-condensing |
Important notices and warnings regarding product usage, storage, and operating temperature.
Precautions regarding installation locations and environmental factors to prevent device failure.
Important safety guidelines and precautions to follow during the operation of the device.
Step-by-step guide for selecting and configuring the video input source.
Instructions for selecting and configuring the audio input source for the device.
Detailed steps for configuring transport type, cast type, target IP, and port settings.
Process for selecting video encoder type (MPEG-2/H.264) and adjusting bitrate.
Guide to setting the bitrate mode (CBR or VBR) and configuring VBR quality.
Steps for selecting the GOP type (IP, IBP, IBBP) and adjusting GOP size.
Instructions for selecting the video profile (e.g., Main, High) for MPEG-2 and H.264.
Steps for configuring the aspect ratio (4:3 or 16:9) for the video input.
Guide to setting the display mode for sync loss detection (Color Bar or Black).
Troubleshooting steps for common problems like power issues, no display, or poor picture quality.
To Next Page