• Coolant selection and maintenance
• Environmental qualities
• Installation
Refer to the standards for the engine or consult with
your Caterpillar dealer in order to determine if the
engine is operating within the defined parameters.
Severe service operation can accelerate component
wear. Engines that operate under severe conditions
may need more frequent maintenance intervals in
order to ensure maximum reliability and retention of
full service life.
Due to individual applications, it is not possible to
identify all of the factors which can contribute to
severe service operation. Consult your Caterpillar
dealer for the unique maintenance that is necessary
for the engine.
The operating environment, improper operating
procedures and improper maintenance procedures
can be factors which contribute to severe service
conditions.
Environmental Factors
Ambient temperatures – The engine may be
exposed to extended operation in extremely cold
environments or hot environments. Valve
components can be damaged by carbon buildup if
the engine is frequently started and stopped in very
cold temperatures. Extremely hot inlet air reduces
engine performance.
Air Quality – The engine may be exposed to
extended operation in an environment that is dirty or
dusty, unless the equipment is cleaned regularly.
Mud, dirt and dust can encase components.
Maintenance can be very difficult. The buildup can
contain corrosive chemicals.
Buildup – Compounds, elements, corrosive
chemicals and salt can damage some components.
Altitude – Problems can arise when the engine is
operated at altitudes that are higher than the
intended settings for that application. Necessary
adjustments should be made.
Improper Operating Procedures
• Extended operation at low idle
• Frequent hot shutdowns
• Operating at excessive loads
• Operating at excessive speeds
• Operating outside the intended application
Improper Maintenance Procedures
• Extending the maintenance intervals
• Failure to use recommended fuel, lubricants and
coolant/antifreeze
i00651416
Starting Motor - Inspect
SMCS Code: 1451-040; 1453-040
Caterpillar Inc. recommends a scheduled inspection
of the starting motor. If the starting motor fails, the
engine may not start in an emergency situation.
Check the starting motor for proper operation. Check
the electrical connections and clean the electrical
connections. Refer to the Service Manual for more
information on the checking procedure and for
specifications or consult your Caterpillar dealer for
assistance.
i05965726
Turbocharger - Inspect
SMCS Code: 1052; 1052-040
Periodic inspection and cleaning are recommended
for the turbocharger compressor housing (inlet side).
Any fumes from the crankcase are filtered through
the air inlet system. Therefore, by-products from oil
and from combustion can collect in the turbocharger
compressor housing. Over time, this buildup can
contribute to loss of engine power, increased black
smoke and overall loss of engine efficiency.
If the turbocharger fails during engine operation,
damage to the turbocharger compressor wheel and/
or to the engine may occur. Damage to the
turbocharger compressor wheel can cause additional
damage to the pistons, the valves, and the cylinder
head.
NOTICE
Turbocharger bearing failures can cause large quan-
tities of oil to enter the air inlet and exhaust systems.
Loss of engine lubricant can result in serious engine
damage.
Minor leakage of a turbocharger housing under ex-
tended low idle operation should not cause problems
as long as a turbocharger bearing failure has not
occurred.
When a turbocharger bearing failure is accompanied
by a significant engine performance loss (exhaust
smoke or engine rpm up at no load), do not continue
engine operation until the turbocharger is repaired or
replaced.
150
SEBU7125-13
Maintenance Section
Starting Motor - Inspect
To Next Page
Loading...