CAT EMCP 4 - 5.9 PROGRAMMABLE CYCLE TIMERS; 5.10 SYSTEM INFORMATION; MODULE INSTALLATION INFO; NETWORK STATUS

To Next Page

To Previous Page

Application and Installation Guide EMCP 4 SCADA Data Links

CRANK/START COUNTERS

The EMCP 4 provides service-related information such as the number of crank and start attempts and

successes.

 Number of Crank Attempts (213)

 Number of Successful Starts (215)

5.9 PROGRAMMABLE CYCLE TIMERS

 Programmable Cycle Timer 1 Output 3 Status (1487)

 Programmable Cycle Timer 2 Output 3 Status (1488)

 Programmable Cycle Timer 3 Output 3 Status (1489)

 Programmable Cycle Timer 4 Output 3 Status (1490)

 Programmable Cycle Timer 5 Output 3 Status (1491)

 Programmable Cycle Timer 6 Output 3 Status (1492)

 Programmable Cycle Timer 7 Output 3 Status (1493)

 Programmable Cycle Timer 1 Output 1 Status (2060)

 Programmable Cycle Timer 2 Output 1 Status (2061)

 Programmable Cycle Timer 3 Output 1 Status (2062)

 Programmable Cycle Timer 4 Output 1 Status (2063)

 Programmable Cycle Timer 5 Output 1 Status (2064)

 Programmable Cycle Timer 6 Output 1 Status (2065)

 Programmable Cycle Timer 7 Output 1 Status (2066)

 Programmable Cycle Timer 1 Output 2 Status (2067)

 Programmable Cycle Timer 2 Output 2 Status (2068)

 Programmable Cycle Timer 3 Output 2 Status (2069)

 Programmable Cycle Timer 4 Output 2 Status (2070)

 Programmable Cycle Timer 5 Output 2 Status (2071)

 Programmable Cycle Timer 6 Output 2 Status (2072)

 Programmable Cycle Timer 7 Output 2 Status (2073)

5.10 SYSTEM INFORMATION

MODULE INSTALLATION INFO

 Genset Control Online (1090) – this refers to the EMCP 4 GSC, and will always return True

 Engine Control Online (1091) – this refers to the ADEM engine ECM, and will return True only if

the ADEM supports CAN communications

 Secondary Engine Control Online (1092)

 External I/O #1 Online (1093) – this refers to a Discrete I/O module configured for Instance #1

 External I/O #2 Online (1094) – this refers to a Discrete I/O module configured for Instance #2

 External I/O #3 Online (1095) – this refers to a Discrete I/O module configured for Instance #3

 External I/O #4 Online (1096) – this refers to a Discrete I/O module configured for Instance #4

 Digital AVR Online (1097) – this refers to a CDVR module

 RTD Module Online (1098)

 Thermocouple #1 Online (1099) – this refers to a Thermocouple module on the Accessory Data Link

 Thermocouple #2 Online (1100) – this refers to a Thermocouple module on the Primary Data Link

 SCR Module Online (1103) – this refers to an SCR (aftertreatment control) module

NETWORK STATUS

These registers indicate the fault status (ok or fault) of the associated networks.