136136
MAINTENANCE
102586 100698
100695A
103246
100814
Park the lift truck with the forks lowered on a
level surface parking brake applied, transmis-
sion in NEUTRAL, engine stopped and the
wheels blocked.
1. Operate the lift truck to warm the oil.
2. Park the lift truck with forks lowered, park-
ing brake applied, transmission in NEU-
TRAL, and engine stopped.
3. Remove the filler cap.
5. Fill the hydraulic tank. See Refill
Capacities. Put the filler cap back on.
6. Start the engine and operate the hydraulic
controls and the steering system through a
few cycles to fill the filters and lines.
7. Retract all hydraulic cylinders and stop the
engine.
8. Remove the filler cap and the dipstick.
Keep the oil level at the HIGH mark on the
dipstick.
NOTICE: When changing fluid consult with
your Cat lift truck dealer.
◆◆
Every 2400 Service Hours or 1 Year, Whichever Comes First
You must read and understand the warnings and instructions contained in this manual before performing any operation or maintenance procedure.
• Hydraulic Oil
Change
Hot oil and components could cause
serious injury. Do not allow hot oil or
components to contact your skin.
The engine has been stopped and the
filler cap is cool enough to remove with
your bare hand.
Remove the filler cap slowly to relieve
pressure.
4. Remove the hydraulic tank drain plug.
Allow the oil to drain. Clean and put the
plug back in place.
• Brake Fluid
Change
9. Put the dipstick and the filler cap back in
place.
Correct level range
WARNING
!
To Next Page
Loading...