8888
Tightening Torque for Rear Wheel Nuts
Unit: N•m (kgf•m) [lbf•ft]
TROUBLESHOOTING
101323 101212
4. Remove the wheel nuts by hand.
5. Firmly grip the tire with both hands, and
remove it from the truck.
1. Tighten the wheel nuts just enough to hold
the tire without rattling, making sure the
clamping surface of each nut comes in full-
face contact with the counterbore of the
wheel disc.
2. Lower the truck until the tire touches the
ground. Tighten the wheel nuts, in two or
three steps, to the specified torque. Each of
the steps must follow the tightening
sequence shown above.
When removing the tire, be careful not to
strip the wheel bolt threads on the edges of
the bolt holes in the rim.
3. Lower the truck, and restore tools and jack.
To Install Tire
103263
Counterbore of
wheel disc
All models
377 (38.5) [278]
CAUTION
!
To Next Page
Loading...