9191
TROUBLESHOOTING
101434C
1. Park the truck in a safe area.
2. Open the engine hood to ventilate the
engine compartment.
3. Allow the engine to idle for a while. DO
NOT attempt to stop the engine.
4. Stop the engine after the coolant tempera-
ture gauge needle has moved into the
WHITE zone.
5. Check for:
– Lack of coolant.
– Loose or broken fan belt.
– Engine oil level.
– Foreign material build-up in radiator air
passages.
– DO NOT attempt to remove the radiator
filler cap if the engine is overheated. This
could cause injury from scalding hot
coolant or steam blowing out of the radiator.
– DO NOT add cold water to an overheated
engine. This can cause damage to the
engine.
– Immediately stop the engine if the fan belt
is broken.
1. Park the truck in a non-traffic area.
2. Apply the parking brake. Place and lock
the direction lever in the NEUTRAL posi-
tion.
Allow the engine to run at low idle for a
while.
3. After the warning light has gone out, oper-
ate the truck again.
◆◆
Engine Coolant Temperature Gauge
Needle Moves into Red Zone
◆◆
Powershift Transmission Oil
Temperature Warning Light Glows
If the warning light does not go out, or if it
glows often, consult your Cat lift truck
dealer.
100813
101440F
WARNING
!
CAUTION
!
To Next Page
Loading...