EasyManua.ls Logo

CAT INV2000 - STORAGE GUIDELINES; Generator Storage Procedures

CAT INV2000
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
21
STORAGE
When a generator is in storage, air may
condense and moisture may appear on the
windings. In order to minimize condensation,
always store the generator in a dry area. Cover
the generator with a protective cover that
extends to the ground. The cover should remain
loose around the generator in order to allow
proper ventilation.
Storage for 1 to 3 months
Remove any dirt, rust, grease, and oil from the
generator. DO NOT use a pressure washer to
clean the generator. Inspect the exterior. Make
any necessary repairs.
Add fuel stabilizer to the fuel tank to prevent the
gasoline from going bad. Start and run the
engine for 5 minutes to ensure that the fuel
stabilizer has been pulled in to the carburetor.
Shut off the engine and allow the engine to cool.
Turn the generator switch to the off “O” position.
Move the generator to the storage place.
Cover the generator.
Storage for more than 3 months
Remove any dirt, rust, grease, and oil from the
generator. DO NOT use a pressure washer to
clean the generator. Inspect the exterior. Make
any necessary repairs.
Gasoline is extremely flammable and is
explosive under certain conditions. Drain the fuel
in a well-ventilated area with the engine stopped
and cool. Never smoke or allow flames or sparks
in the area during
this procedure.
Remove the fuel cap and carefully turn the
generator over to pour the gasoline into an
appropriate container. Reinstall the fuel cap and
start and run the engine until the engine stops,
to allow the fuel to drain from the fuel lines,
carburetor, and engine system.
Change the engine oil. Refer to Engine Oil –
Change.
Remove the spark plug and pour a small amount
of oil into the cylinder. Install the spark plug but
do not install the spark plug boot.
Turn the generator switch to the off “O” position.
Move the generator to the storage place.
Cover the generator.

Related product manuals