When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
If you open the door , the machine will pause. the buzzer will mooing
every minute unless you close the door . After you close the door ,the machine will keep
on working after 10 seconds.
during a wash cycle
A forgotten dish can be added any time before the detergent cup opens.
Add forgotten dishes.
Close the door
After the spray arms stop working,you can open the door
completely.
2
3
1
4
5
Press the Start/Reset button
Press the Start/Reset button, the dishwasher will run
after 10 seconds.
A cycle that is underway can only be modified if it has only been running for a short
time. Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water. If this is the case, the detergent dispenser must
be refilled (see the section entitled " Loading the Detergent " ).
,the dishwasher will be paused the Start/Reset 3
current
The shows the state of the dishwasher:
a)One of the program lights on-----------------------------> stand by or pause;
b)One of the program lights blinking slowly -------------> run;
c)Some of the the program lights fast blinking-----------> error.
1
2
3
Press the Start/Reset button , then press button more than
seconds to cancel the program , you can change the program to the desired cycle setting
(see the section entitled " Starting a wash cycle. . . " ).
indicator light
Premise
It is dangerous to open the door when washing,
because the hot water may scald you.
To Next Page
Loading...
