Catalina 310 - MONTHLY MAINTENANCE: RIGGING; HULL AND DECK (Maintenance); ENGINE (Maintenance)

HULL AND DECK:
1. Inspect hull valves open and close freely.
2. Winches turn freely, lubricate as per manufacturer's recommendations.
3. Clean and wax gel coat surfaces as necessary.
ENGINE:
1. Check oil and fluid levels, visually check for fluid leaks.
2. Battery: Check fluid levels and tie downs.
3. Tighten all bolts and nuts to proper torque.
4. Check fuel tank fittings and hose clamps.
5. Disassemble and inspect cooling system anti-siphon
6. Check bolts.
7. Check filters.
SEASONAL MAINTENANCE:
RIGGING:
1. Mast head pins and sheaves turn freely.
2. Halyards and shackles are in good condition. (Refer to Rigging, Stepping the Mast)
3. Spreader tips and bases, and mast fittings OK.
4. All shroud terminations and swedged fittings OK, check for cracks or corrosion.
5. Gooseneck assembly and boom assembly OK.
6. Mast, boom and spreaders cleaned and waxed.
7. Lifelines, pelican hooks, and stanchions all OK, all pins and fittings are secure, cotter
rings taped. Turnbuckles, pelican hooks and connector loops OK, screw fittings
checked for thread wear.
HULL, DECK and CABIN:
1. All chainplates and through bolts tight.
2. Disassemble winches and lubricate bearings and pawls.
3. Inspect and coat electrical system connections, battery tie downs and terminal
connectors to prevent corrosion.
4. Drain and flush fresh water system.
11