Need help?Do you have a question about the Catalinbread Talisman and is the answer not in the manual?
Introduces the Talisman pedal, its inspiration from the EMT 140 plate reverb, and its sonic qualities.
Provides instructions for connecting the Talisman to an amplifier for initial testing on a clean setting.
Advises on integrating the Talisman into an amplifier's effects loop or as the last pedal in a chain.
Explains how PRE DELAY controls reverb onset timing and HIGH PASS filters low frequencies.
Details the MIX control for effect level, TIME for decay length, and PRE DELAY for reverb reflection.
Describes the VOL knob's output control and its behavior in different bypass modes.
Explains the internal slider switch for selecting between Buffered and True Bypass modes.
Offers guidance on where to place the Talisman within an effects chain for desired sonic results.
Details power supply requirements and lists the pedal's technical specifications.
Power| power supply voltage | 9-18 vDC |
|---|---|
| current draw | 62 mA |
Weight and Dimensions| length | 11.11 cm |
|---|---|
| width | 6 cm |
| height | 4.76 cm |
To Next Page