6
Basic Operation
1. Turn on STB
Make the connection as given in the connection diagram.
Turn on the STB by switching on the adaptor mains power supply.
2. Standby
Press[Standby] key for the STB to enter the Standby state.
In Standby state, press [Standby] key again to recall the last channel.
User can also disconnect the device’s main power to end the Standby state.
3. Channel Up/Channel Down
In full screen, press [CH+/CH-] to change channel.
4. Volume Up/Volume Down
In full screen, press [VOL+/VOL-] to adjust volume.
5. Number Keys
In full screen, use number key and press [OK] on the Remote Control Unit to change
channel.
6. Mute
Press [MUTE] key to mute the sound and the screen will show up mute on the screen.
Press [MUTE] key again to restore sound.
7. Pause
In play mode, press [PAUSE] key, the picture will be paused.
Press [PAUSE] key again, the screen’s picture will skip over to the current playing picture,
and the sound of the channel will play correspondingly.
8. Audio
In full screen, press [AUDIO] key to open the “Audio Setting” window on the screen.
9. TV/Radio
In TV mode, pressing [TV/RADIO] key can switch to Radio mode.
In Radio mode, press [TV/RADIO] key to switch to TV mode.
10. Channel List
Press the [OK] key while the program is playing in full screen to open channel list.
11. Recall
In full screen press [RECALL] key to switch to the last viewed channel. The program name
and channel information are displayed at the bottom of the screen.
To Next Page
Loading...
