ii AH0054602-00 J
User’s Guide—Converged Network Adapters
41xxx Series
Document Revision History
Revision A, April 28, 2017
Revision B, August 24, 2017
Revision C, October 1, 2017
Revision D, January 24, 2018
Revision E, March 15, 2018
Revision F, April 19, 2018
Revision G, May 22, 2018
Revision H, August 23, 2018
Rev
ision J, January 24, 2019
Changes Sections Affected
In Table 2-2, updated the OS requirements:
Removed support for Windows Nano. Added
support for 2008 SP2 R2 SP2 and Windows
2019.
Removed support for RHEL 6.8, 7.2, 7.3, 7.4.
Added support for RHEL 7.5 and 7.6.
Removed support for SLES 11 SP4 and
SLES 12 SP2. Added support for SLES 15.
Removed support for ESXi 6.0 U3 and later for
25G adapters. Added support for vSphere ESXi
6.5 U2 and vSphere ESXi 6.7 U1.
“System Requirements” on page 4
Following Step 4, added a note: “The maximum
number of supported qedentv Ethernet interfaces
on an ESXi host is 32, because the vmkernel
allows only 32 interfaces to register for manage-
ment callback.”
“Installing VMware Drivers” on page 29
Added a note describing the driver limitation as it
applies to the iSCSI vmnic.
“iSCSI Support” on page 34
Moved iSCSI boot from SAN information from the
iSCSI Configuration chapter to a new chapter.
Added and corrected iSCSI BFS information.
Chapter 6 Boot from SAN Configuration
Moved FCoE boot from SAN information from the
FCoE Configuration chapter to a new chapter.
Added and corrected FCoE BFS information.
Chapter 6 Boot from SAN Configuration
To Next Page
Loading...