3.FAQ
1.Why does not the screen light up after the connection and plugging of USB or
power supply?
Answer：
⑴ Wrong connection of power supply jumper cap.
⑵ Poor contact of flat cable on both sides of screen. It is recommended
to pull out and plug again.
(3) If you use a power adapter, you can check whether the switch
interfaces is shorting or not.
2. Why does not the limit switch stop after trigger?
Answer：
⑴ Wrong setting of direction of electrical machine.
⑵ Wrong setting of structure type of limit switch in terms of machine
parameters.
3. The electrical motor does not rotate？
Answer：Wrong connection of electrical motor and false identification
between inverting and non-inverting.
4. Failure in installation of drive? （ChuTu V 3.6 support WIN 8.1 /7/XP）
Answer：At first, you can install the drive(PL2303TA) file in the folder. If
failed, you can download from official website of PL2303TA drive, or
you can one-click install by using the Driver Genius and other driver
installation software
Driver Genius download:
http://www.driver-soft.com/download.html
To Next Page
Loading...