Screw the 510 thread magnetic connector onto your cartridge and drop into
the slot of the device.
Draw directly from cartridge to activate.
*To prevent overheating, the battery will cut off any session over 10
seconds.
*To avoid residue, remove the cartridge when not in use.
ASSEMBLY AND USE
AIRFLOW SETTINGS
The gap on the airflow collar can be adjusted to increase or decrease
airflow.
Less dense clouds
and cooler vapors
Happy medium for
flavor and clouds
Warm, dense,
and tasty clouds
PREHEAT SETTINGS
Start Preheat
Short-press the power button twice to start preheating.
*A full preheat session lasts for 10 seconds with all LED lights blinking.
End Preheat
Press the power button to stop the preheat in advance.
To start using before the end of preheating, simply draw from the
cartridge.
To Next Page
Loading...
