VOLTAGE SETTINGS
Voltage Check
During inhalation, the LED light(s) will indicate the voltage in use.
2.8V 3.2V 3.6V
Switching Voltages
The default voltage is 2.8V. To switch between different voltage
settings, long-press the power button and the LED light(s) will blink
3 times to indicate the voltage in use.
2.8V 3.2V 3.6V
BATTERY AND CHARGING
Battery Level (Charging)
During charging, the LED light(s) will blink accordingly to indicate the
battery level.
40%-70%≥70% <40%
Battery Level (Not Charging)
Short-press the power button once to activate LED indication.
≥70% 40%-70% 10%-40% <10%
Charging
Remove the cartridge before charging the device.
Insert a USB-C cable into the charging port to start charging. A full
charge requires approximately 90 minutes.
When the device is fully charged, all three light bars will blink 3 times.
To Next Page
Loading...
