18
Note: If you choose to set a dened drying time this will automatically
be at the default drying level for the programme selected.
Refer to the drying programme list on page 22 for details of drying
options available for each programme.
Delay timer
A delay of up to 23 hours can be set before the start time for the
programme, in half hour increments to allow the wash programme to
start at a convenient time.
The “Delay” function is not available for the “Spin” programme.
To set the delay timer:
• Press the “Delay” button. “0.5h” will show on the display.
• Pressing the “Delay” button again increases the delay by 30
minutes for each press, up to the maximum of 23 hours.
• Once the required time delay is shown on the display, the washer
dryer will set after approximately three seconds delay.
To cancel the time delay function after pressing the “Start” button:
It is only necessary to press the “Delay” button once and the machine
will start its programme.
Start
Press the “Start” button to start the selected wash programme
running, the indicator light stays on. If this is pressed again while
the machine is running a programme the washer will pause and the
indicator light will flash.
To Next Page
Loading...
