7
To Switch Heating Zones On
When the mains power supply is switched on, the buzzer beeps
once and all the indicators light up for 1 second, then go out. This
indicates that the ceramic hob has entered standby mode.
Touch the ON/OFF control, all the indicators show “-“.
Place a suitable pan on the cooking zone that you wish to use
(see “Efficient Use of Your Hob” section for selection of suitable
pans).
Ensure the bottom of the pan and the surface of the cooking zone
are clean and dry.
Touch the heating zone selection control that corresponds to the
zone where the pan is placed (for example back ).
Select a heat setting by touching the or controls. You may
select any power level from “1” to “9”.
If you don’t choose a heat setting within approx. 1 minute, the
ceramic hob will automatically switch off.
You can change the heat setting at any time during cooking.
By holding down either of these controls, the power level will
adjust up or down.
To use more than one heating zone, just touch the control for the
next one you want to use, then select the power level for that (as
above).
To Switch Heating Zones Off
Touch the heating zone selection control that corresponds to the
To Next Page
Loading...
Need help?
General
