TABLE OF CONTENTS
Safety Information I
Introduction 1-1
Functional Description and Specifications 2-1
Functional Descriptions 2-1
SURETEST Torque Calibration System 2-1
Base Unit 2-2
• Front Panel 2-2
• Rear Panel (Input/Output) 2-9
Torque Transducers 2-11
Specifications 2-12
SURETEST Torque Calibration System 2-12
• SURETEST Base Unit 2-12
• Transducers 2-13
• 600TL (LOADER) 2-14
Setup and Programming 3-1
SURETEST Torque Calibration System Setup 3-1
Back panel connections 3-1
Setting Up the SURETEST System 3-2
SURETEST Base Unit Controls 3-3
Powering the Equipment 3-3
Transducer Select 3-4
Programming Setup 3-5
• Setting up Date and Time 3-5
• Setting Up High and Low Limits Alert 3-5
• Programming AUTO Settings 3-6
DATA LIST Memory 3-7
• Clear single memory location 3-8
• Clear all memory location 3-8
Setting Up Printer/PC Ports 3-8
Torque Calibration System Setup 4-1
Testing Torque Wrenches and Drivers 4-1
Selecting a Transducer 4-1
Installing a Transducer 4-1
Dial and Bending Beam Torque Wrenches and Screwdrivers 4-2
Adjustable or Preset “Click” Wrenches and Screwdrivers 4-3
Testing Power Tools 4-4
Non-Impact Tools 4-4
Statistical Analysis 4-7
• Displaying Statistical Analysis on LCD 4-7
• Printing Statistical Analysis 4-8
Displaying or Downloading Data List 4-10
How to Use Analog Output (Rear Panel BNC Connector) 4-11
Calibration 5-1
Mounting Details 5-1
Quick Check 5-4
Torque Transducer Calibration 5-7
TABLE OF CONTENTS 1
To Next Page
Loading...
