CDP UPO22 - Page 19

01: Output voltage
Interface
Setting
Parameter 3: Output voltage
208:
220:
230:
240:
02: Output frequency
Interface
Setting
60 Hz, Normal mode
50 Hz, CVCF mode
ATO
Parameter 2: Output Frequency
50.0Hz:
60.0Hz:
ATO:
Parameter 3: Frequency mode
CF:
NCF:
Note: For single unit, it will have bypass output for a couple of seconds after the unit is powered
on. Therefore, to avoid damage on connected devices, it s strongly suggested to add an additional
Output relay board for CVCF application.
03: Voltage range for bypass
Interface
Setting
Parameter 2:
Parameter 3:
18