What to do if there is resistance when the sealing belt is conveying in my CE CLEVELAND CE-2500-HVE Food Saver?
If you notice resistance while the sealing belt is conveying, the clearance between the heating blocks or cooling blocks might be too small, causing excessive friction. To resolve this, adjust the clearance between the sealing belts to approximately the thickness of a packing bag in one layer.
What to do if there is blockage when the packing bag is conveyed to pinching the roller or embossing roller in CE CLEVELAND CE-2500-HVE?
If the packing bag experiences blockage or folding when conveyed to the pinch roller or embossing roller, it could be due to excessive pressure applied by these rollers. Adjust the pressure of the pinch roller or embossing roller to a more appropriate level. Also, adjust the limiting screw after adjusting clearance.
Why is the sealing belt easy to break on my CE CLEVELAND Food Saver?
The sealing belt might break easily due to several reasons: * Too much tension on the sealing belt. You can adjust the vertical adjusting screw on the driven wheel seat to decrease the tension. * Lack of crease on the sealing belt. * The surface of the sealing belt is not cleaned regularly. * The clearance between the two heating blocks is too small, or the temperature is too high.
Why don't the conveyor belt and sealing belt move synchronously on my CE CLEVELAND CE-2500-HVE?
If the conveyor belt and sealing belt aren’t moving synchronously, it could be due to: * Too little tension on the conveyor belt. To fix this, tighten the chain of the driving roller shaft (front shaft) and the middle shaft properly. * The conveyor belt is not tightened properly. Tighten the conveyor belt properly.
How to fix low definition embossing on CE CLEVELAND Food Saver?
Low definition embossing can occur if the embossing roller is worn out; in this case, replace the embossing roller. Alternatively, the pressure spring on the embossing roller might not be tightened enough. Adjust the embossing roller’s tightening spring to increase the pressure.
How to fix a CE CLEVELAND CE-2500-HVE conveying belt that is off track?
If the conveying belt is off track, the driving roller shaft might not be parallel to the driven roller shaft. You can fix this by adjusting the two adjusting screws for the driven roller shaft (rear shaft) on the conveyor.
How to fix sealing belt off tracking on CE CLEVELAND CE-2500-HVE Food Saver?
If the sealing belt is off tracking, it may be because the driving wheel shaft is not parallel to the driven wheel shaft. Adjust the two adjusting screws on the driven wheel seat to correct this.
General| Brand | CE CLEVELAND |
|---|---|
| Model | CE-2500-HVE |
| Category | Food Saver |
| Language | English |
To Next Page