POWER INSTANT-CCINO 20
4140
ENGLISH ENGLISH
Thoroughly dry the device and all accessories before assembling it again.
Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to clean the
device, these can damage the surface.
Auto-cleaning
Quick cleaning of the milk tank system:
Fill the milk tank with water.
Fold out the milk tank’s nozzle (8) using the lever (7).
Press the on/off button to (16) turn the device on and preheat water. During the preheating
process, the control panel will flash.
Place a suitable cup below the milk tank’s nozzle.
As soon as the device has heated up, the control panel will stop flashing. Press button (20), the
machine will beep indicating that the self-cleaning cycle has started.
Once the cycle is over, pour away all the cleaning rests.
Repeat this process if necessary.
Intensive cleaning of the portafilter and milk tank system:
Fill the milk and water tank with water.
Fold out the milk tank’s nozzle (8) using the lever (7).
Press the on/off button to (16) turn the device on and preheat water. During the preheating
process, the control panel will flash.
Place a suitable cup below the coffee spout (14) and the milk tank’s nozzle.
As soon as the device has heated up, the control panel will stop flashing. Press button (20) for
5 seconds approx., the machine will beep indicating that the self-cleaning cycle has started.
The cleaning cycle can be stopped by pressing the same button again, the device will switch
to standby mode.
Once the cycle is over, pour away all the cleaning rests.
Repeat this process if necessary.
Descaling
Limescale deposits have an adverse effect not only on the quality of the espresso and the
water, but they also cause power losses and shorten the lifespan of the device. Possible signs
that indicate that descaling is required are a large amount of steam being produced and slower
brewing. The machine indicates when cleaning or descaling is required by lighting up the
yellow light indicator (22). Use anti-scale cleaning agents regularly, every 2-6 weeks, in order
to avoid the machine from blocking and from operating in bad conditions.
Storage
Disconnect the device from the mains power when it is not going to be used for a long period
of time. Clean the device again if necessary and let it dry completely. Store the device and all
accessories in a dry, clean, safe place that is protected from direct sunlight and cannot be
accessed by children or animals.
5. TROUBLESHOOTING
Warning: Do not attempt to repair defective electrical devices by yourself!
Problem Possible cause Solution
The red light indicator
is on.
There is not enough water in
the tank.
Fill the water tank.
The yellow light indicator
blinks.
The device is blocked. Descale the device.
Espresso comes out very
slow
Coffee spout or filter is
blocked.
Clean the portafilter and
filter.
The device is blocked. Descale the device.
Coffee is tamped too hard. Refill the filter basket with
coffee, do not tamp too much.
Coffee is ground too finely. Use coffee with thicker
grinding level.
Coffee is too weak. Not enough coffee in filter. Pour the exact amount of
coffee in the filter.
The preset amount of coffee
is more than the amount of
coffee powder in the filter.
Set the correct amount of
coffee in the machine and in
the filter.
A lot of steam is produced
during the brewing
process.
Cappuccino, latte macchiato
or milk froth has been
selected but there is no milk
in the milk tank.
Wait until the programme
has finished and allow
the machine to cool down.
Remove the milk tank, fill it
and put it back, then operate
again.
The device is blocked. Descale the device.
To Next Page
Loading...
