cecotec BAMBA CERAMICCARE SUPERSONIC - Attaching and Removing the Heads; Head Attachment and Removal Procedures; Operation; Appliance Operation and Settings

BAMBA CERAMICCARE SUPERSONIC
29
ENGLISH
3. ATTACHING AND REMOVING THE HEADS
- To attach the heads, place the desired head on the body of the appliance matching the
mark on the head with the open padlock symbol on the locking piece of the body. Then turn
the locking piece until the mark on the head is aligned with the closed padlock symbol of
the locking piece. Fig. 2
- To remove the heads, turn the locking piece until the mark on the head is aligned with the
open padlock symbol of the locking piece. Then hold the body of the appliance with one
hand and gently pull the head with the other hand to remove it. Fig. 3
4. OPERATION
1. Wash and condition your hair.
2. Dry your hair with a towel and comb it.
3. Ensure that the mains voltage matches the voltage specied on the appliance rating label
and that the plug is earthed. Plug the appliance to a power supply.
4. Align the desired brush attachment with the slots and turn the locking piece to the locked
position.
5. Use the switch to turn the appliance on and set it to the desired air speed.
6. Press the temperature-setting button repeatedly to select between cool, warm, or hot
air. The LED temperature indicator lights will light up blue for cool air, yellow for warm air,
and red for hot air.
7. With the warm and hot temperature settings enabled, you can briey cool down the
air temperature (cool shot) by holding down the temperature-setting button for a
few seconds. When the button is released, the appliance will return to the selected
temperature setting.
8. Switch the appliance o by setting the switch to the O position and unplug it from the
mains socket after use.
9. To remove the attachment, turn the locking piece to the unlocked position and gently pull
the attachment out.
Using the curlers
1. With your hair at least 85% dry, place the curler on the side of the head whose hair you
wish to curl rst.
2. Separate the hair into approximately 2 cm strands.
3. Select a warm or hot temperature setting.
4. Bring the end of the hair strand close to the curler: the latter will attract the hair thanks to
the Coandă eect and curl it.
5. Keep the hair wound on the curler for a few seconds and then apply a shot of cold air to x
the hairstyle.