cecotec BAMBA CERAMICCARE SUPERSONIC - Cleaning and Maintenance; General Cleaning Procedures; Cleaning the Air-Inlet Filter; Troubleshooting

BAMBA CERAMICCARE SUPERSONIC
30
ENGLISH
6. Switch o the appliance and unwind the hair from the top. Repeat these steps with the
next strand until all hair on that side of the head is curled.
7. Replace the curler with the one t for the hair on the opposite side of the head and do the
same.
After use
1. Turn the appliance o and unplug it.
2. Place it on a heat-resistant surface until it cools down.
3. Remove the hair and dust from the appliance and attachments.
4. Clean the appliance with a soft cloth and store it in a dry place.
5. CLEANING AND MAINTENANCE
- Unplug the appliance from the power supply and allow it to cool down before cleaning.
- Use a soft, damp cloth to clean the surface of the appliance.
- Do not immerse the appliance in water or other liquids.
- Do not use abrasive cleaners or scouring pads to clean the appliance.
- Do not twist, bend, pull, or damage the power cable.
- Clean the dirt and hairs that may be clogging the appliance.
Cleaning the lter:
- Turn the air-inlet lter cover to unlock it and gently pull it downwards.
- Use a soft brush or a cotton swab to clean the air-inlet lter.
- Ret the cover by turning it to lock it in place. Fig. 4
6. TROUBLESHOOTING
Problem Possible causes
It does not
work properly.
Check if the appliance is correctly plugged in.
Check if the attachment is correctly tted.
Check if the appliance switched o due to overheating.
Set air speed to 0, unplug the appliance, and let it to cool down properly.
Before turning it back on, make sure that nothing is clogging the air inlet.